08系列绝码编码盘
Series 08 stainless steel absolute 4...20mA encoder up to 1/2" |
| 0 8XX-06XX-0XXX Shaft Size | | Resolution10 = 10 mm||360 = 1 ramp per turn12 = 12 mm||180 = 2 ramps per turn||090 = 4 ramps per turnConnectionHousing Material1 = 2 m (6 ft) cableS = Stainless Steel2 = 5 m (16 ft) cable4 = 15 m (50 ft) cable Precision: 10 bits in 360 degrees, 2.84 increments / degree
Zone 0, Class 1 Div 1 |
| Technical Data | Connection Options | |||
| Operating temp: | - 20 ...+ 60 degrees C | Cable 2 meters | ||
| - 4 ...+ 140 degrees F | + Loop | Red | ||
| Max frequency: | 5 kHz | - Loop | Black | |
| Supply Voltage: | 24V (current loop) | |||
| Weight: | 26 oz (0.75 kg) | Output | ||
| Protection: | IP 66 / X7 M | Diagram is shown clockwise | ||
Housing and Shaft: | Stainless Steel |
*4...20mA span based on 250 ohm load | ||
Bearings: | 3 x 6803 ZZ C2 | |||
Torque: | 0.8 oz/in (6 N-cm) | |||
Shaft load: | Supports its own weight | |||
Humidity: | Up to 100% permissible | |||
Speed: | 2000 RPM max. | |||
Max. bits: | 10 bit | |||
| Certifications |
| Best suited to work with the following isolators: MTL5541 |
| IP67M |
| ATEX |
| IECEx |
| CSA |
| GOST (CU) |
| Mounting Instructions |
Mount the tether on the machine or motor-frame. The tether can be bent to adapt to any surface. This assembly allows the encoder to float and increases the lifetime of the bearings. Connect the encoder as per wiring specifications. Make sure power supply is within the proper voltage and current rating. Encoder can be mounted with the setscrew on the machine side or on the opposite side for either CW or CCW. See datasheet for CW and CCW directions of the outputs.
Technical data for tether: 0.3 mm stainless steel sheet
|
| Dimensions |
|
